3350 W. 48th Pl. Chicago, IL 60632-3000. Phone 773-927-3484, FAX 773-650-5853.
Source for liquid thermosets: silicones, moldmaking urethanes, casting urethanes, polyester resins, epoxy.
Fiberglass fabrics, release agents, fillers and dyes.
All products available in small quantity.

EP 9801 Two-Component Urethane

 

GENERAL DESCRIPTION:  EP9801 is a two component, casting urethane primarily formulated for the manufacture of non-structural or decorative items.  EP9801 provides the following outstanding features:

                (1)           Low viscosity, ~ 75 cps (Water-like)

                (2)           Convenient volumetric mix ratio

                (3)           Rapid set time for high productivity

                (4)           Low odor, which dissipates after cure             

                (5)           Excellent reproduction of even the finest detail

                (6)           Readily accepts paints, stains and finishes

                (7)           Tough, break-resistant character


                Mix Ratio:              1:1 by Volume

                Pot Life:                 1-2 min.

                Cure Time:             10-20 min. (depends on temperature, humidity, casting thickness)


CAUTION: DO NOT OVERMIX. STIR VIGOROUSLY FOR 10 SECONDS MAXIMUM. OVERMIXING WILL CAUSE AIR BUBBLES AND SOLVENT LEAKAGE FROM CURED PART.

 

Urethanes are extremely water sensitive: The slightest moisture that comes into contact with either part A, part B or the curing mixture could may cause incomplete curing and/or foaming. Take the necessary precautions (close the caps on containers tightly; do not blow on curing resin; make sure mold is dry prior to casting).   he resultant room temperature cured plastic has these properties:

                                Specific Gravity                                    1.02

                                Hardness (durometer)                         70 D

                                Tensile Strength                                   2300 psi

                                Elongation                                             10%

                                Shrinkage                                              Negligible

                                Heat Distortion Temperature             130°F


EP9801 is available in the following sizes:

                                2 Pint Kit                                2 lb

                                2 Quart Kit                             4 lb

                                2 Gallon Kit                           16 lb

                                2 5 Gallon Kit                        80 lb

                                2 55 Gallon Drum Kit            950 lb


Warning:  Uncured EP 9801 may cause respiratory & skin irritation with possible sensitization.  Use only with adequate ventilation.  If skin contact occurs, wash thoroughly with soap and water.  In case of eye contact, flood with water & call a physician.  Use of gloves and face shield is recommended.  EP9801 should not be used near food or where prolonged skin contact may occur.

Disclaimer:  This information is based on sources that we believe to be accurate. It is offered in good faith, but without guarantee, since conditions of use are beyond our control. All risk of use are assumed by the user.

 

 



Eager Home | Catalog | Moldmaking Silicone | Flexible Urethane | Casting Plastic | Pigments & Dyes | Epoxy
Fiberglass Fabric & Polyester Resin | Fillers & Powders | Release Agents | MSDS | FAQ | How-to Books
Finished Product Examples | Shipping Options | Placing an Order | Versión español | E-mail Us


All content © copyright 2001 Eager Plastics, Inc. and may not be republished without permission.