Eager Plastics, inc.

3350 W. 48th Pl  Chicago, IL 60632

Phone:  773-927-3484

Back to our homepage at: www.eagerplastics.com

 

MATERIAL SAFETY DATA SHEET

- EP 9801 Part B -

 

I     PRODUCT IDENTIFICATION

 

PRODUCT NAME:   EP 9801 Part B

CHEMICAL TYPE:  Extended Polyether Polyol

 

II     INGREDIENTS

 

COMPONENTS:                                %                                TLV (ACGIH)

Polyether Polyol

(CAS Unassigned)                                47                                Not established

Catalytic Reformer Distillate                                53                                5 mg(mineral oil                                      mist)/m3

Ingredients not precisely identified are proprietary

 

III     PHYSICAL DATA

 

APPEARANCE & ODOR:                                Amber liquid with                                 slight petroleum odor

BOILING POINT:                                360oF

SPECIFIC GRAVITY:                                .9898 at 20oC

VAPOR PRESSURE:                                .09mm Hg at 38oC

SOLUBILITY IN WATER:                                Partial

 

IV     FIRE AND EXPLOSION DATA

 

FLASH POINT:   151oF  Pensky-Martin

EXTINGUISHING MEDIA:   Dry chemical, carbon dioxide, high expansion (proteinic) chemical foam, water spray for large fires.

SPECIAL FIRE FIGHTING PROCEDURES:   Full emergency equipment with self-contained breathing apparatus and full protective clothing should be worn by firefighters.  Product may float and can be reignited on water surface.  Vapors are heavier than air and may travel a distance to a source of ignition and flash back.

UNUSUAL FIRE OR EXPLOSION HAZARDS:  Combustible liquid.  Explosive rupture is possible.  Therefore, use cold water to cool fire exposed containers.

V     REACTIVITY DATA

 

STABILITY:   Stable under normal conditions

INCOMPATIBILITY (MATERIALS TO AVOID):   Heat, flame and contact with strong oxidizing agents.

HAZARDOUS POLYMERIZATION:   Will not occur

HAZARDOUS DECOMPOSITION PRODUCTS:   By high heat and fire: toxic oxides of carbon and sulfur, hydrocarbons and hydrocarbon derivatives.

 

VI     HEALTH HAZARD DATA

 

GENERAL:   No toxicity information is available on this specific preparation; this health hazard assessment is based on information that is available on the properties of its components.

PRIMARY ROUTE(S) OF ENTRY:   Skin; Inhalation

INHALATION:   Irritation of the upper respiratory tract with central nervous system stimulation possibly followed by depression, dizziness, headache, drowsiness, incoordination, anesthesia, lung congestion, coma and respiratory arrest.

SKIN CONTACT:   Defatting may occur with continued or prolonged contact. Irritation and burning sensation may occur on exposure to liquid or vapor phase..

EYE CONTACT:   Liquid will cause severe burning sensation with temporary irritation and swelling of lids.

INGESTION:   Irritation of mucous membranes of throat, esophagus and stomach which may result in nausea and vomiting, depression may occur if absorbed. Central nervous system depression with extreme overexposure; effects may include anesthesia, coma, respiratory arrest and irregular heart rate.

CARCINOGENICITY: None of the ingredients are listed by NTP, IARC, or regulated by OSHA as a carcinogen.

FIRST AID PROCEDURES:

   Skin:  Wash material off skin with plenty of soap and water.  For severe exposures, get under safety shower after removing clothing, then get medical attention.  For lesser exposure, seek medical attention if irritation develops or persists after the area is washed.  Do not reuse clothing until cleaned.

   Eyes:  Flush with copious amounts of water for at least 15 minutes holding eyelids open.  Get medical attention immediately.

   Ingestion:  DO NOT INDUCE VOMITING.  Extreme care must be used to prevent aspiration.  Do not give anything by mouth to an unconscious person.  Get medical attention immediately.  

   Inhalation:  Move to area free of risk to further exposure.  Administer oxygen or artificial respiration as needed.  Get medical attention.

 

VII     SPILL OR LEAK PROCEDURES

 

STEPS TO BE TAKEN IN CASE MATERIAL IS RELEASED OR SPILLED:   Remove all possible ignition sources.  Evacuate and ventilate spill area; dike spill to prevent entry into water system; wear full protective equipment during cleanup.

Major Spill:   Large quantities may be pumped into closed, but not sealed container for disposal.

Minor Spill:  Absorb material with sawdust or other absorbent, shovel into suitable unsealed containers, transport to well-ventilated area (outside).

Clean-up:  Decontaminate floor with decontaminating solution, letting stand for at least 15 minutes.

WASTE DISPOSAL METHOD:   Waste must be disposed of according to federal, state and local environmental control regulations.  Decontaminate containers prior to disposal.  Empty containers should be crushed to prevent reuse.  DO NOT HEAT OR CUT EMPTY CONTAINER WITH ELECTRIC OR GAS TORCH.  Vapors and gases may be toxic.

 

VIII     SPECIAL PROTECTION

 

EYE PROTECTION:   Liquid chemical goggles or full face shield.

SKIN PROTECTION: Chemical resistant gloves recommended.

RESPIRATORY PROTECTION:   Because of low vapor pressure, ventilation is usually sufficient to keep vapors below the TLV at room temperatures.  If concentrations exceed the TLV, use MSHA/NIOSH approved positive pressure supplied air respirator to prevent overexposure.

VENTILATION:   Local exhaust should be used to keep airborne concentrations below the TLV.

 

IX     SPECIAL PRECAUTIONS

 

Store in tightly sealed containers to protect from atmospheric moisture.  Educate and train employees in safe use of product.

 

 

 

X     REGULATORY INFORMATION

 

TSCA (Toxic Substances Control Act) Regulations, 40 CFR 710:   All ingredients are on the TSCA Section 8(b) Inventory.

 

CERCLA and SARA Regulations (40 CFR 355,370, and 372):

Section 313 Supplier Notification.  This product contains the following toxic chemicals subject to the reporting requirements of Section 313 of the Emergency Planning and Community Right-To-Know Act of 1986 and of 40 CFR 372:  NONE

State Regulations:

California Proposition 65: : This product does not contain chemicals known to the State of California to cause cancer, birth defects or other reproductive harm.

DOT Classification: Not regulated in non-bulk packaging. Bulk packaging in a maximum capacity greater than 119 gallons is required to have shipping papers marked as Combustible liquid n.o.s., 3, UN 1993, PG III and display appropriate placards.

 

The information contained herein is furnished without warranty of any kind.  Users should consider these data only as a supplement to other information gathered by them and must make independent determinations of suitability and completeness of information from all sources to assure proper use and disposal of these materials and the safety and health of employees and customers.

 

Date prepared:   12/97

Date revised:       1/2000